Windows 7 Netbook Edition Build 7264 – Included Orbit Activator in RAR
The Eee7 is a special version of Windows 7 Ultimate, based on the last edition 7264, made by thegroup “ModMyEee” and occupies only 1,49 GB USB drive and at 4 Gb hard disk. Operates on any netbook, the Eee PC 7 “4GB, until the last Sony Vaio P seriesand is faster and the XP SP3. No major operation has not been deducted. All networking capabilities remained intact. Hardware support is not removed.
Some of the thingsthat have been removed:
Old drivers, games, Asian languages (can be added later), the files, and more.
To be able to install the netbook due to lack of dvd drive,we shouldprepare a USB Flash to make it bootable.
What we need
* USB Flash Drive (2GB more)
* The DVD which we burned the image of the iso that you downloaded
* A computer withVista / Windows 7
Step 1: Formating the USB Flash
The following steps we will use the command prompt to create the appropriate Usb flash fomat with diskpart. [Note: Itwill erase all the data on USB Flash, be careful.
1. Connect the USB Flash Drive
2. Open the command prompt as …………. (Go Start> AllPrograms> Accesories, right click on the “Command Prompt” and select “Run as ………….”
3. To find out what numbercorresponds to the USB Flash Drive you should type the following in the window of the “Command Prompt”:
diskpart
list disk
The number corresponding to your USBwill be appear in the list (see the USB and the capacity of)
This number will need in the next step. Suppose that the USB Flash Drive is the disk 1.
4. Format the USBtyping the following commands in the same window. Attention, replace the number “1″ on disk 1 to the number of your drive as emerged from the abovelist.
select disk 1
clean
create partition primary
select partition 1
active
format fs = NTFS
assign
exit
When you enter this, you will have a USB Flash Drive formattedready to be bootable.
Step 2: Let’s make the USB bootable
we will use the application bootsect that is in the EEE7 DVD.
We will use the same command prompt windowfrom Step 1:
1. Put the dvd of Eee7 in the drive of your computer.
2. Change the drive in the command prompt with that which is your drive. Suppose that the DVD drive isD:
cd d: boot
3. We will use the bootsect to define the USB as a bootable NTFS drive ready to accept the Eee7.
Suppose that the USB Flash Drive is G: , your position inG: put the letter of your USB.
Enter:
bootsect / nt60 g:
4. You can close the command prompt,now the USB is bootable.
Step 3: Copy files from DVD to USB Flash drive
Theeasiest way is through the windows. Copy all files from DVD and paste it in the USB flash drive. Just copy all the files, you’re ready.
Step 4: Set the BIOS to bootfrom USB
DOWNLOAD and Don't Forget say THANKS.

http://hotfile.com/list/316231/ce8f700